During the last couple of days, I have noticed a problem while burning. Hi gentlemen, well, I installed a 5/8 inch gasket the other day and also installed the spare handle and everything seemed to go together very well. I read a thread about using 3/8 " rope (the same as the one used in the door gasket.) Thanks for taking an interest in helping me out. Do you have any suggestions as to how to best remove the door gasket? I thought that any leftover residue could be removed with a small wood chisel and then finish it off with course steel wool? Are you aware of the size of the door gasket? I also need to replace the baffle gasket and I just know that's going to be a real treat because I refuse to buy the cheap ones that Pacific Energy sell because they break too easily. Next week I'll replace the gasket and perhaps install a new handle because I had purchased a couple back in the day. The latch is snug when closed and I do notice a big difference in both consumption of wood and longer burn times. I did however manage to use a tool to "fluff" up the door gasket as it’s quite old. Yesterday, I took the door off and tried tightening the nut again but to no avail. Hi Jeff, from the beginning the handle has always been a problem as I could never seem to get the hexagon nut tight enough.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |